Prodigal Ponderings — prodigal how to's RSS



My Best Finishing Tip Update

On my December 4, 2017 blog post titled “My Best Finishing Tip for Hardwoods” I closed with my “Key Storage Tip” which had worked for me in the past. Well now I’m here to add to that tip.  If there’s one thing I’ve learned from woodworking it’s to never think you have it all figured out, in other words, remain teachable!My key storage tip worked well for me until I got down to my can being about half empty, then I discovered that no matter how well I had sealed the can I was getting a film on the top of my finish.  After doing some research and once again relying on the expertise of other woodworkers I found that...

Continue reading



My Best Finishing Tip for Hardwoods

After doing plenty of research and trying multiple methods I came up with my own process of finishing hardwoods for products that do not come in direct contact with food. I’ve used this process on chess boards, lathe pieces (such as candle holders and pepper mills) along with coaster sets, etc. The finish is clear, hard and beautiful! Before I begin I’ll tell you what I tried previously: 1. Minwax Paste Finishing Wax: a nice starter product that applies easy and protects the wood, but hardly an “eye popping” finish 2. Boiled Linseed Oil covered with Instant Bond Wood Adhesive: better, but not great 3. A variety of other finishes I saw online but again, none matched the success below:...

Continue reading



Jet Lathe 1221VS Review

I’ve been a lathe owner for a little less than a year so I am in no way qualifying myself as an expert.  That said, I have created several salt and pepper mills and chess pieces that have received high compliments so I am an active lathe user.   Like many of my “turning” friends I started by purchasing a rather inexpensive 12” lathe from Harbor Freight.  If you have about $80 to spend (even less with a HF coupon) and want to see if turning is your thing, I highly recommend this route.  I burned this lathe out after a few months trying to drill center holes in my ginders.   So, after a few weeks of pondering and...

Continue reading



Trying Something New

Once I began to hone my craft from hobbyist to woodworker, my friends began to take notice of the quality and creativity of my craftsmanship. With that came plenty of suggestions: "have you considered making.....?" Although flattered I have also become a realist who recognizes very quickly the limits of my skills or the time and effort that would be involved in trying certain things. As every woodworker advances we also become more aware of our own idiosyncrasies that we factor into any project.  I am one who gets distracted easily so simply making the same thing over and over again, no matter how good I've become at it, becomes less interesting let alone challenging. Enter new challenges worth tackling. One of...

Continue reading



Choosing Wood for End Grain Cutting Boards

After making dozens of end grain cutting boards over the past couple years I wanted to share a bit about which woods I consider the best (and most available) for constructing boards.  We’ve said, time and again, that end grain is the premium construction method for cutting boards because of it’s antibacterial properties and kindness to our knife edges. A crucial basis for determining the wood we use is in it’s hardness.  I’ve found the best online source for wood characteristics, including hardness is:  http://www.wood-database.com/  When looking through the database, try to select wood in the hardness range of 850 - 1700; You also want to look for a hardwood with a relatively tight grain pattern, free of knots and other blemishes.  The most common...

Continue reading